CC1150-RTY1 datasheet(38/67 Pages) TI1

38 / 67 page

BALUN,

Matching and

Filtering

Antenna

Filter

CC1150

SWRS037B – JANUARY 2006 – REVISED MARCH 2015

www.ti.com

5.19.6 Low-Cost Systems

As the CC1150 provides 500-kBaud multi-channel performance without any external filters, a very low cost

system can be made. A HC-49 type SMD crystal is used in the CC1150EM reference design (see [1] and

[2]).

NOTE

The crystal package strongly influences the price. In a size constrained PCB design a

smaller, but more expensive, crystal may be used.

5.19.7 Battery-Operated Systems

In low power applications, the SLEEP state should be used when the CC1150 is not active.

5.19.8 Increasing Output Power

In some applications it may be necessary to extend the link range. Adding an external power amplifier is

the most effective way of doing this.

The power amplifier should be inserted between the antenna and the balun as shown in Figure 5-18.

Figure 5-18. Block Diagram of CC1150 Usage with External Power Amplifier

5.20 Memory

The configuration of CC1150 is done by programming 8-bit registers. The configuration data based on

selected system parameters are most easily found by using the SmartRF Studio [11] software. Complete

descriptions of the registers are given in Section 5.20.1. After chip reset, all the registers have default

values as shown in the tables. The optimum register setting might differ from the default value. After a

reset, all registers that shall be different from the default value therefore needs to be programmed through

the SPI interface.

There are 9 Command Strobe Registers, listed in Table 5-11 Accessing these registers will initiate the

change of an internal state or mode. There are 29 normal 8-bit Configuration Registers, listed in Table 5-

12. Many of these registers are for test purposes only, and need not be written for normal operation of

CC1150.

There are also 6 Status registers, which are listed in Table 5-13. These registers, which are read-only,

contain information about the status of CC1150.

The TX FIFO is accessed through one 8-bit register. Only write operations are allowed to the TX FIFO.

During the address transfer and while writing to a register or the TX FIFO, a status byte is returned. This

status byte is described in Table 5-2.

Detailed Description

Submit Documentation Feedback

Product Folder Links: CC1150

CC1150-RTY1 Datasheet(PDF) 38 Page - Texas Instruments