USB3370 datasheet(39/75 Pages) MICROCHIP

39 / 75 page

 2012 - 2015 Microchip Technology Inc.

DS00001915B-page 39

USB3370

Transfer of the RXCMD byte occurs in Synchronous Mode when the PHY has control of the bus. The ULPI Protocol

Block shown in Figure 6-1 determines when to send an RXCMD. A RXCMD will occur:

• When a linestate change occurs.

• When VBUS or ID comparators change state.

• During a USB receive when NXT is low.

• After the USB3370 deasserts DIR and STP is low during start-up

• After the USB3370 exits Low Power Mode, Serial Modes, or Carkit Mode after detecting that the Link has de-

asserted STP, and DIR is low.

When a USB Receive is occurring, RXCMD’s are sent whenever NXT = 0 and DIR = 1. During a USB Transmit, the

RXCMD’s are returned to the Link after STP is asserted.

If an RXCMD event occurs during a Hi-Speed USB transmit, the RXCMD is blocked until STP de-asserts at the end of

the transmit. The RXCMD contains the status that is current at the time the RXCMD is sent.

FIGURE 6-7:

ULPI RXCMD TIMING

TABLE 6-3:

ULPI RX CMD ENCODING

Data [7:0]

Name

Description and Value

[1:0]

Linestate

UTMI Linestate Signals. See Section 6.3.1.1

[3:2]

Encoded

VBUS State

ENCODED VBUS VOLTAGE STATES

VALUE

VBUS VOLTAGE

SESSEND

SESSVLD

VBUSVLD2

VVBUS < VSESS_END

VSESS_END < VVBUS <

VSESS_VLD

VSESS_VLD < VVBUS <

VVBUS_VLD

VVBUS_VLD < VVBUS

[5:4]

Rx Event

Encoding

ENCODED UTMI EVENT SIGNALS

VALUE

RXACTIVE

RXERROR

HOSTDISCONNECT

DIR

CLK

DATA[7:0]

STP

NXT

RXCMD

Idle

Turn around

RXCMD

Idle

Turn around

RXCMD

USB3370 Datasheet(PDF) 39 Page - Microchip Technology

USB3370 Datasheet(HTML) 39 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75

Datasheet Download

Link URL