EM357-RTR datasheet(73/240 Pages) ETC2

73 / 240 page

EM351 / EM357

8.2

Configuration

Before using a serial controller, configure and initialize it as follows:

Set up the parameters specific to the operating mode (master/slave for SPI, baud rate for UART, etc.).

Configure the GPIO pins used by the serial controller as shown in Table 8-1 and Table 8-2. Section 2 in

Chapter 7, GPIO shows how to configure GPIO pins.

If using DMA, set up the DMA and buffers. This is described fully in section 8.7.

If using interrupts, select edge- or level-triggered interrupts with the SCx_INTMODE register, enable

the desired second-level interrupt sources in the INT_SCxCFG register, and finally enable the top-level

SCx interrupt in the NVIC.

Write the serial interface operating mode — SPI, TWI, or UART — to the SCx_MODE register.

Table 8-1. SC1 GPIO Usage and Configuration

PB1

PB2

PB3

PB4

SPI - Master

SC1MOSI

Alternate Output

(push-pull)

SC1MISO

Input

SC1SCLK

Alternate Output

(push-pull)

(not used)

SPI - Slave

SC1MISO

Alternate Output

(push-pull)

SC1MOSI

Input

SC1SCLK

Input

SC1nSSEL

Input

TWI - Master

SC1SDA

Alternate Output

(open-drain)

SC1SCL

Alternate Output

(open-drain)

(not used)

UART

TXD

Alternate Output

(push-pull)

RXD

Input

nCTS

Input1

nRTS

Alternate Output (push-

pull)1

1 used if RTS/CTS hardware flow control is enabled.

Table 8-2. SC2 GPIO Usage and Configuration

PA0

PA1

PA2

PA3

SPI - Master

SC2MOSI

Alternate Output

(push-pull)

SC2MISO

Input

SC2SCLK

Alternate Output

(push-pull)

(not used)

SPI - Slave

SC2MOSI

Input

SC2MISO

Alternate Output

(push-pull)

SC2SCLK

Input

SC2nSSEL

Input

TWI - Master

(not used)

SC2SDA

Alternate Output

(open-drain)

SC2SCL

Alternate Output

(open-drain)

(not used)

8-2

120-035X-000D

Preliminary

EM357-RTR Datasheet(PDF) 73 Page - List of Unclassifed Manufacturers

EM357-RTR Datasheet(HTML) 73 Page - List of Unclassifed Manufacturers

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL