IS25LP256D-RLLA3 datasheet(76/174 Pages) ISSI

76 / 174 page

IS25LP256D

IS25WP256D

Integrated Silicon Solution, Inc.- www.issi.com

Rev A6

04/15/2019

8.11 QUAD INPUT PAGE PROGRAM OPERATION (PPQ, 32h/38h or 4PPQ, 34h/3Eh)

The Quad Input Page Program instruction allows up to 256 bytes data to be programmed into memory in a single

operation with four pins (IO0, IO1, IO2 and IO3). The destination of the memory to be programmed must be outside

the protected memory area set by the Block Protection (BP3, BP2, BP1, BP0) bits or ASP. A Quad Input Page

Program instruction which attempts to program into a page that is write-protected will be ignored.

Before the execution of Quad Input Page Program instruction,

the QE bit in the Status Register must be set to “1”

and the Write Enable Latch (WEL) must be enabled through a Write Enable (WREN) instruction.

 32h/38h (EXTADD=0) is followed by a 3-byte address (A23-A0) or

 32h/38h (EXTADD=1) is followed by a 4-byte address (A31-A0) or

 34h/3Eh is followed by a 4-byte address (A31-A0)

Program operation will start immediately after the CE# is brought high, otherwise the Quad Input Page Program

instruction will not be executed. The internal control logic automatically handles the programming voltages and

timing. The progress or completion of the program operation can be determined by reading the WIP bit. If the WIP

bit is “1”, the program operation is still in progress. If WIP bit is “0”, the program operation has completed.

If more than 256 bytes data are sent to a device, the address counter rolls over within the same page, the previously

latched data are discarded, and the last 256 bytes data are kept to be programmed into the page. The starting byte

can be anywhere within the page. When the end of the page is reached, the address will wrap around to the

beginning of the same page. If the data to be programmed are less than a full page, the data of all other bytes on

the same page will remain unchanged.

Note: A program operation can alter “1”s into “0”s, but an erase operation is required to change “0”s back to “1”s. A

byte cannot be reprogrammed without first erasing the whole sector or block.

Figure 8.25 Quad Input Page Program operation (32h/38h [EXTADD=0], 3-byte address)

Instruction = 32h/38h

CE #

SCK

3-byte Address

High Impedance

...

Mode 3

Mode 0

IO0

IO1

Data In 2

IO2

IO3

...

Data In 1

...

IS25LP256D-RLLA3 Datasheet(PDF) 76 Page - Integrated Silicon Solution, Inc

IS25LP256D-RLLA3 Datasheet(HTML) 76 Page - Integrated Silicon Solution, Inc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL