HD6432138SW datasheet(409/1061 Pages) RENESAS

409 / 1061 page

Section 13 Timer Connection [H8S/2138 Group]

Rev. 4.00 Jun 06, 2006 page 355 of 1004

REJ09B0301-0400

MSTPCRH Bit 4—Module Stop (MSTP12): Specifies 8-bit timer channel 0 and 1 module stop

mode.

MSTPCRH

Bit 4

MSTP12

Description

8-bit timer channel 0 and 1 module stop mode is cleared

8-bit timer channel 0 and 1 module stop mode is set

(Initial value)

MSTPCRH Bit 0—Module Stop (MSTP8): Specifies 8-bit timer channel X and Y and timer

connection module stop mode.

MSTPCRH

Bit 0

MSTP8

Description

8-bit timer channel X and Y and timer connection module stop mode is cleared

8-bit timer channel X and Y and timer connection module stop mode is set

(Initial value)

13.3

Operation

13.3.1

PWM Decoding (PDC Signal Generation)

The timer connection facility and TMRX can be used to decode a PWM signal in which 0 and 1

are represented by the pulse width. To do this, a signal in which a rising edge is generated at

regular intervals must be selected as the IHI signal.

The timer counter (TCNT) in TMRX is set to count the internal clock pulses and to be cleared on

the rising edge of the external reset signal (IHI signal). The value to be used as the threshold for

deciding the pulse width is written in TCORB. The PWM decoder contains a delay latch which

uses the IHI signal as data and compare-match signal B (CMB) as a clock, and the state of the IHI

signal (the result of the pulse width decision) at the compare-match signal B timing after TCNT is

reset by the rise of the IHI signal is output as the PDC signal. The pulse width setting using

TICRR and TICRF of TMRX can be used to determine the pulse width decision threshold.

Examples of TCR and TCORB settings are shown in tables 13.3 and 13.4, and the timing chart is

shown in figure 13.2.

HD6432138SW Datasheet(PDF) 409 Page - Renesas Technology Corp