EDBA164B4PR-1DITF-R datasheet(84/152 Pages) MICRON

84 / 152 page

(tZQINIT, tZQCL, or tZQCS). The quiet time on the data bus helps to calibrate output im-

pedance accurately. There is no required quiet time after the ZQRESET command. If

multiple devices share a single ZQ resistor, only one device can be calibrating at any giv-

en time. After calibration is complete, the ZQ ball circuitry is disabled to reduce power

consumption.

In systems sharing a ZQ resistor between devices, the controller must prevent tZQINIT,

tZQCS, and tZQCL overlap between the devices. ZQRESET overlap is acceptable. If the

ZQ resistor is absent from the system, ZQ must be connected to VDD2. In this situation,

the device must ignore ZQ calibration commands and the device will use the default

calibration settings.

Figure 55: ZQ Timings

Notes:

1. Only the NOP command is supported during ZQ calibrations

tZQINIT: ZQ calibration initialization period

tZQCS: ZQ calibration short period

t ZQCL: ZQ calibration long period

tZQRESET: ZQ calibration reset period

216-Ball and 220-Ball, Dual-Channel LPDDR2 SDRAM

MODE REGISTER WRITE Command

09005aef85eb530a

216b_220b_2ch_2e0e_embedded_lpddr2.pdf – Rev. F 08 /16 EN

Micron Technology, Inc. reserves the right to change products or specifications without notice.

EDBA164B4PR-1DITF-R Datasheet(PDF) 84 Page - Micron Technology