5

© KEMET Electronics Corporation • P.O. Box 5928 • Greenville, SC 29606 (864) 963-6300 • www.kemet.com C1081_C0G_HV_FT_AUTO_SMD • 2/29/2016

Surface Mount Multilayer Ceramic Chip Capacitors (SMD MLCCs)

High Voltage with Flexible Termination System (HV FT-CAP), C0G Dielectric, 500 – 3,000 VDC (Automotive Grade)

Electrical Parameters/Characteristics

Item

Parameters/Characteristics

Operating Temperature Range

−55°C to +125°C

Capacitance Change with Reference to +25°C and 0 VDC Applied (TCC)

±30 ppm/ºC

Aging Rate (Maximum % Capacitance Loss/Decade Hour)

0%

1

Dielectric Withstanding Voltage (DWV)

150% of rated voltage for voltage rating of < 1,000 V

120% of rated voltage for voltage rating of ≥ 1,000 V

(5 ±1 seconds and charge/discharge not exceeding 50 mA)

2

Dissipation Factor (DF) Maximum Limit at 25ºC

0.1%

3

Insulation Resistance (IR) Limit at 25°C

1,000 megohm microfarads or 100 GΩ

(500 VDC applied for 120 ±5 seconds at 25°C)

1

DWV is the voltage a capacitor can withstand (survive) for a short period of time. It exceeds the nominal and continuous working voltage of the capacitor.

2

Capacitance and dissipation factor (DF) measured under the following conditions:

1 MHz ±100 kHz and 1.0 Vrms ±0.2 V if capacitance ≤ 1,000 pF

1 kHz ±50 Hz and 1.0 Vrms ±0.2 V if capacitance > 1,000 pF

3

To obtain IR limit, divide MΩ-µF value by the capacitance and compare to GΩ limit. Select the lower of the two limits.

Note: When measuring capacitance it is important to ensure the set voltage level is held constant. The HP4284 and Agilent E4980 have a feature known as

Automatic Level Control (ALC). The ALC feature should be switched to “ON.”

Post Environmental Limits

High Temperature Life, Biased Humidity, Moisture Resistance

Dielectric

Rated DC

Voltage

Capacitance

Value

Dissipation Factor

(Maximum %)

Capacitance

Shift

Insulation

Resistance

C0G

All

All

0.5

0.3% or ±0.25 pF 10% of Initial Limit