HD6432138SW datasheet(213/1061 Pages) RENESAS

213 / 1061 page

Section 7 Data Transfer Controller [H8S/2138 Group]

Rev. 4.00 Jun 06, 2006 page 159 of 1004

REJ09B0301-0400

Section 7 Data Transfer Controller [H8S/2138 Group]

Provided in the H8S/2138 Group; not provided in the H8S/2134 Group.

7.1

Overview

The H8S/2138 Group includes a data transfer controller (DTC). The DTC can be activated by an

interrupt or software, to transfer data.

7.1.1

Features

• Transfer possible over any number of channels

 Transfer information is stored in memory

 One activation source can trigger a number of data transfers (chain transfer)

• Wide range of transfer modes

 Normal, repeat, and block transfer modes available

 Incrementing, decrementing, and fixing of transfer source and destination addresses can be

selected

• Direct specification of 16-Mbyte address space possible

 24-bit transfer source and destination addresses can be specified

• Transfer can be set in byte or word units

• A CPU interrupt can be requested for the interrupt that activated the DTC

 An interrupt request can be issued to the CPU after one data transfer ends

 An interrupt request can be issued to the CPU after all specified data transfers have ended

• Activation by software is possible

• Module stop mode can be set

 The initial setting enables DTC registers to be accessed. DTC operation is halted by setting

module stop mode

HD6432138SW Datasheet(PDF) 213 Page - Renesas Technology Corp