FT51BQ-R datasheet(14/43 Pages) FTDI

14 / 43 page

FT51A Advanced MCU with 8051 Compatible Core IC Datasheet

Version 1.5

Doc ument N o.: FT _000877

C learance N o.: FT DI#420

3.2.11

USB XCVR

The USB Transceiver Cell provides the USB 2.0 full-speed physical interface to the USB cable. The output

drivers provide +3.3V level slew rate control signalling, whilst a differential input receiver and two single

ended input receivers provide USB data in, Single -Ended-0 (SE0) and USB reset detection conditions

respectfully. This function also incorporates a 1.5kΩ pull up resistor on the USBUPDP pin.

3.2.12

IO Multiplexer

With the addition of the IO multiplexer any function can be configured to any DIO pin, excluding the

analogue ADC function which is constrained to the AIO pins. All other digital functionality is

recommended to map to DIO pins. The IO multiplexer allows the designer to select which peripherals are

connected to which IO pins. In order to assign a signal to a particular pin, two register writes are

required, one to select the signal and the other to select the IO pin. The FT51A Programmer’s Guide

details the pins and signals which can be connected.

The selectable peripheral interfaces are only limited by the number of IO pins available. The number of

IOs available is dependent on the package type.

Table 3-2 lists the peripherals which can be multiplexed to IO and the typical number of pins required for

each one. The designer can choose any mix of peripheral configurations as long as they are within the

specific package IO pin count.

Peripherals

Number of pins required

(typical)

UART (FTDI)

UART (8051)

ADC

1-16

8051 Port 0-3

SPI Master

SPI Slave

245 FIFO

I2C Master

I2C Slave

PWM

1-8

Table 3-2 – Peripheral Pin Requirements

3.2.13

I2C Master

The FT51A provides an interface between the core and an I2C bus. It can be programmed to operate with

arbitration and clock synchronization allowing it to operate in multi‐master systems. I2C Master supports

transmission speeds up to 3.4 Mb/s including Normal, Fast and High Speed modes .

FT51BQ-R Datasheet(PDF) 14 Page - Future Technology Devices International Ltd.

FT51BQ-R Datasheet(HTML) 14 Page - Future Technology Devices International Ltd.

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43

Datasheet Download

Link URL