M30620FCAFP datasheet(493/615 Pages) RENESAS

493 / 615 page

Power Control

Mitsubishi microcomputers

M16C / 62A Group

SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER

2-176

Address

00000

Interrupt

information

BCLK

Address bus

Data bus

Indeterminate

SP-2

SP-4

vec

vec+2

Indeterminate

SP-2

contents

SP-4

contents

vec

contents

vec+2

contents

Writing “1” to CM10

(all clock stop control bit)

Oscillation start-up

Stop mode

Interrupt sequence approximately 20 cycle (13µ sec)

(Single-chip mode, f(XIN) = 16MHz)

Indeterminate

Operated by divided-by-8 mode

INTi

Shown above is the case where the main clock is selected for BCLK. If the sub-clock is selected for BCLK,

the sub-clock functions as BCLK when restored from stop mode, with the main clock's divide ratio

unchanged.

Note:

(5) Sequence of returning from stop mode

Sequence of returning from stop mode is oscillation start-up time and interrupt sequence.

When interrupt is generated in stop mode, CM10 becomes “0” and clearing stop mode.

Starting oscillation and supplying BCLK execute the interrupt sequence as follow:

In the interrupt sequence, the processor carries out the following in sequence given:

(a) CPU gets the interrupt information (the interrupt number and interrupt request level) by read-

ing address 0000016. The interrupt request bit of the interrupt written in address 0000016 will

then be set to “0”.

(b) Saves the content of the flag register (FLG) as it was immediately before the start of interrupt

sequence in the temporary register (Note) within the CPU.

flag (U flag) to “0” (the U flag, however does not change if the INT instruction, in software

interrupt numbers 32 through 63, is executed)

(d) Saves the content of the temporary register (Note) within the CPU in the stack area.

(e) Saves the content of the program counter (PC) in the stack area.

(f) Sets the interrupt priority level of the accepted instruction in the IPL.

Note: This register cannot be utilized by the user.

After the interrupt sequence is completed, the processor resumes executing instruc-

tions from the first address of the interrupt routine.

Figure 2.15.2 shows the sequence of returning from stop mode.

Figure 2.15.2. Sequence of returning from stop mode

(6) Registers related to power control

Figure 2.15.3 shows the memory map of power control-related registers, and Figure 2.15.4 shows

power control-related registers.

Figure 2.15.3. Memory map of power control-related registers

000616

000716

System clock control register 0 (CM0)

System clock control register 1 (CM1)

M30620FCAFP Datasheet(PDF) 493 Page - Renesas Technology Corp

M30620FCAFP Datasheet(HTML) 493 Page - Renesas Technology Corp

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL