HD6432138SW datasheet(239/1061 Pages) RENESAS

239 / 1061 page

Section 7 Data Transfer Controller [H8S/2138 Group]

Rev. 4.00 Jun 06, 2006 page 185 of 1004

REJ09B0301-0400

7.3.12

Examples of Use of the DTC

Normal Mode: An example is shown in which the DTC is used to receive 128 bytes of data via

the SCI.

1. Set MRA to fixed source address (SM1 = SM0 = 0), incrementing destination address (DM1 =

1, DM0 = 0), normal mode (MD1 = MD0 = 0), and byte size (Sz = 0). The DTS bit can have

any value. Set MRB for one data transfer by one interrupt (CHNE = 0, DISEL = 0). Set the

SCI RDR address in SAR, the start address of the RAM area where the data will be received in

DAR, and 128 (H'0080) in CRA. CRB can be set to any value.

2. Set the start address of the register information at the DTC vector address.

3. Set the corresponding bit in DTCER to 1.

4. Set the SCI to the appropriate receive mode. Set the RIE bit in SCR to 1 to enable the reception

complete (RXI) interrupt. Since the generation of a receive error during the SCI reception

operation will disable subsequent reception, the CPU should be enabled to accept receive error

interrupts.

5. Each time reception of one byte of data ends on the SCI, the RDRF flag in SSR is set to 1, an

RXI interrupt is generated, and the DTC is activated. The receive data is transferred from RDR

to RAM by the DTC. DAR is incremented and CRA is decremented. The RDRF flag is

automatically cleared to 0.

6. When CRA becomes 0 after the 128 data transfers have ended, the RDRF flag is held at 1, the

DTCE bit is cleared to 0, and an RXI interrupt request is sent to the CPU. The interrupt

handling routine should perform wrap-up processing.

HD6432138SW Datasheet(PDF) 239 Page - Renesas Technology Corp