HD6432138SW datasheet(178/1061 Pages) RENESAS

178 / 1061 page

Section 5 Interrupt Controller

Rev. 4.00 Jun 06, 2006 page 124 of 1004

REJ09B0301-0400

5.5.2

Interrupt Control Mode 0

Enabling and disabling of IRQ interrupts and on-chip supporting module interrupts can be set by

means of the I bit in the CPU’s CCR, and ICR. Interrupts are enabled when the I bit is cleared to

0, and disabled when set to 1. Control level 1 interrupt sources have higher priority.

Figure 5.8 shows a flowchart of the interrupt acceptance operation in this case.

1. If an interrupt source occurs when the corresponding interrupt enable bit is set to 1, an

interrupt request is sent to the interrupt controller.

2. When interrupt requests are sent to the interrupt controller, a control level 1 interrupt,

according to the control level set in ICR, has priority for selection, and other interrupt requests

are held pending. If a number of interrupt requests with the same control level setting are

generated at the same time, the interrupt request with the highest priority according to the

priority system shown in table 5.4 is selected.

3. The I bit is then referenced. If the I bit is cleared to 0, the interrupt request is accepted. If the I

bit is set to 1, only NMI and address break interrupts are accepted, and other interrupt requests

are held pending.

4. When an interrupt request is accepted, interrupt exception handling starts after execution of the

current instruction has been completed.

5. The PC and CCR are saved to the stack area by interrupt exception handling. The PC saved on

the stack shows the address of the first instruction to be executed after returning from the

interrupt handling routine.

6. Next, the I bit in CCR is set to 1. This disables all interrupts except NMI and address break

interrupts.

7. A vector address is generated for the accepted interrupt, and execution of the interrupt

handling routine starts at the address indicated by the contents of that vector address.

HD6432138SW Datasheet(PDF) 178 Page - Renesas Technology Corp