HD6432138SW datasheet(177/1061 Pages) RENESAS

177 / 1061 page

Section 5 Interrupt Controller

Rev. 4.00 Jun 06, 2006 page 123 of 1004

REJ09B0301-0400

Table 5.6

Interrupts Selected in Each Interrupt Control Mode

Interrupt Mask Bits

Interrupt Control Mode

Selected Interrupts

All interrupts (control level 1 has priority)

NMI and address break interrupts

All interrupts (control level 1 has priority)

NMI, address break and control level 1

interrupts

NMI and address break interrupts

Legend:

*: Don’t care

Default Priority Determination: The priority is determined for the selected interrupt, and a

vector number is generated.

If the same value is set for ICR, acceptance of multiple interrupts is enabled, and so only the

interrupt source with the highest priority according to the preset default priorities is selected and

has a vector number generated.

Interrupt sources with a lower priority than the accepted interrupt source are held pending.

Table 5.7 shows operations and control signal functions in each interrupt control mode.

Table 5.7

Operations and Control Signal Functions in Each Interrupt Control Mode

Setting

Interrupt Acceptance Control

3-Level Control

Interrupt

Control Mode

INTM1

INTM0

ICR

Default Priority

Determination

(Trace)

—

Legend:

Interrupt operation control performed

IM: Used as interrupt mask bit

PR: Sets priority

—:

Not used

HD6432138SW Datasheet(PDF) 177 Page - Renesas Technology Corp

HD6432138SW Datasheet(HTML) 177 Page - Renesas Technology Corp

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL