Gasket Maker Anaerobic Adhesives

GM10 • GM18 • GM74

Handling

Information

Directions for Use:

for use on most plastics due to potential cracking of plastic parts. Also, they are

not recommended for use in piping systems that contain pure oxygen or an

oxygen-rich environment, chlorine, or strong oxidizing substances.

For Assembly:

1. Ensure parts are clean, dry and free from oil, grease and dirt. For best

Activator. (Activator can also be used on inactive surfaces or to accelerate

Activator may reduce bond strength depending on substrates and gap.

Testing is recommended to evaluate the effect.

2. If not sure of surface type, always use activator. Refer to Material surface

Activity and Cure Speed section for more information.

3. Apply a continuous bead of adhesive by had tracing or by automated

tracing equipment onto one surface of the flange or mating part. Circle all

also be applied by screen printing, roll coating, pads, etc.

4. Assemble parts and tighten as soon as possible. Making sure to apply

fastening pressure evenly on all sides of the mated assemblies.