■ Precautions

5.Mounting Procedures

⑴ Removal of the cap

Use the notch on the side of the cap and pull up.

Remove the cap with the switch in the up position.

LP

⑷ Panel cutout

When cutting out the panel, press through the panel from the front

side. Also make sure to mount the switch from the front side of the

panel as shown in the figure below. This will help the mount spring

on both sides of the switch latch on to the edge of the hole. Note

that the vertical play of the switch when mounted is 0.3 mm max..

⑶ Mounting the Switch Guard

Concave

Filter

Cap

Conve

Concave

Front side of the panel

Back side of the panel

⑵ Mounting the cap

A) Insert the Älter into the cap. The Älter is reversible.

B) Mate and snap in the two recesses on the inner side of the

cap

to the tabs on the side of the actuator of the switch.