ADP1650ACBZ-R7 datasheet(28/32 Pages) AD

28 / 32 page

ADP1650

Rev. 0 | Page 28 of 32

PCB LAYOUT

Poor layout can affect performance, causing electromagnetic

interference (EMI) and electromagnetic compatibility (EMC)

problems, ground bounce, and power losses. Poor layout can

also affect regulation and stability. Figure 44 shows optimized

layouts implemented using the following guidelines:

•

Place the inductor, input capacitor, and output capacitor

close to the IC using short tracks. These components carry

high switching frequencies and large currents.

•

Route the trace from the inductor to the SW pin with as

wide a trace as possible. The easiest path is through the

center of the output capacitor.

•

Route the LED_OUT path away from the inductor and SW

node to minimize noise and magnetic interference.

•

Maximize the size of ground metal on the component side

to help with thermal dissipation.

•

Use a ground plane with two to three vias connecting to the

component side ground near the output capacitor to

reduce noise interference on sensitive circuit nodes.

•

Analog Devices applications engineers can be contacted

through the Analog Devices sales team to discuss different

layouts based on system design constraints.

DIGITAL

INPUT/

OUTPUT

Li-ION +

PGND

INDUCTOR

LED

ANODE

AREA = 16.4mm2

Figure 43. Layout of the ADP1650 Driving a High Power White LED

ADP1650ACBZ-R7 Datasheet(PDF) 28 Page - Analog Devices