7643 datasheet(91/424 Pages) RENESAS

91 / 424 page

Rev.2.00

Aug 28, 2006

page 74 of 103

REJ09B0133-0200

OVERVIEW

FLASH MEMORY MODE

7643 Group

Fig. 73 CPU rewrite mode set/release flowchart

End

Start

Execute read array command or reset flash

memory by setting flash memory reset bit (by

writing “1” and then “0” in succession) (Note 3)

Single-chip mode, Memory expansion mode or

Boot mode

Set CPU mode registers A, B (Note 2)

Using software command execute erase,

program, or other operation

Jump to control program transferred in memory

other than internal flash memory

(Subsequent operations are executed by control

program in this memory)

Transfer CPU rewrite mode control program to

memory other than internal flash memory

Notes1: When starting the MCU in the single-chip mode or memory expansion mode, supply

4.5 V to 5.25 V to the CNVss pin until checking the CPU rewrite mode entry flag.

2: Set the main clock as follows depending on the XIN divider select bit of clock control

When XIN divider select bit = “0” (

φ = f(XIN)/4), the main clock is 24 MHz or less

When XIN divider select bit = “1” (

φ = f(XIN)/2), the main clock is 12 MHz or less.

3: Before exiting the CPU rewrite mode after completing erase or program operation,

always be sure to execute the read array command or reset the flash memory.

Write “0” to CPU rewrite mode select bit

Set CPU rewrite mode select bit to “1” (by

writing “0” and then “1” in succession)

Check CPU rewrite mode entry flag

Setting

Released

7643 Datasheet(PDF) 91 Page - Renesas Technology Corp