HD6432138SW datasheet(698/1061 Pages) RENESAS

698 / 1061 page

Section 22 ROM (H8S/2138 F-ZTAT A-Mask Version, H8S/2134 F-ZTAT A-Mask Version)

Rev. 4.00 Jun 06, 2006 page 644 of 1004

REJ09B0301-0400

• In boot mode, if any data has been programmed into the flash memory (if all data is not 1), all

flash memory blocks are erased. Boot mode is for use when user program mode is unavailable,

such as the first time on-board programming is performed, or if the program activated in user

program mode is accidentally erased.

• Interrupts cannot be used while the flash memory is being programmed or erased.

• The RxD1 and TxD1 pins should be pulled up on the board.

• Before branching to the programming control program (RAM area H'(FF)E080), the chip

terminates transmit and receive operations by the on-chip SCI (channel 1) (by clearing the RE

and TE bits in SCR to 0), but the adjusted bit rate value remains set in BRR. The transmit data

output pin, TxD1, goes to the high-level output state (P84DDR = 1, P84DR = 1).

The contents of the CPU’s internal general registers are undefined at this time, so these

registers must be initialized immediately after branching to the programming control program.

In particular, since the stack pointer (SP) is used implicitly in subroutine calls, etc., a stack area

must be specified for use by the programming control program.

The initial values of other on-chip registers are not changed.

• Boot mode can be entered by making the pin settings shown in table 22.6 and executing a

reset-start.

When the chip detects the boot mode setting at reset release*

1, P92, P91, and P90 can be used

as I/O ports.

Boot mode can be cleared by driving the reset pin low, waiting at least 20 states, then setting

the mode pins, and executing reset release*

1. Boot mode can also be cleared by a WDT

overflow reset. The mode pin input levels must not be changed in boot mode.

• If the mode pin input levels are changed (for example, from low to high) during a reset, the

state of ports with multiplexed address functions and bus control output pins (

AS, RD, HWR)

will change according to the change in the microcomputer’s operating mode*

Therefore, care must be taken to make pin settings to prevent these pins from becoming output

signal pins during a reset, or to prevent collision with signals outside the microcomputer.

Notes: 1. Mode pins input must satisfy the mode programming setup time (t

MDS = 4 states) with

respect to the reset release timing.

2. Ports with multiplexed address functions will output a low level as the address signal if

mode pin setting is for mode 1 is entered during a reset. In other modes, the port pins

go to the high-impedance state. The bus control output signals will output a high level

if mode pin setting is for mode 1 is entered during a reset. In other modes, the port pins

go to the high-impedance state.

HD6432138SW Datasheet(PDF) 698 Page - Renesas Technology Corp