NRF24L01P-R7 datasheet(56/78 Pages) NORDIC

56 / 78 page

Revision 1.0

Page 56 of 78

nRF24L01+ Product Specification

You can write to the TX FIFO using these three commands; W_TX_PAYLOAD and

W_TX_PAYLOAD_NO_ACK

in PTX mode and W_ACK_PAYLOAD in PRX mode. All three commands provide

access to the TX_PLD register (see Table 28. on page 63. for details of this register).

The RX FIFO can be read by the command R_RX_PAYLOAD in PTX and PRX mode. This command pro-

vides access to the RX_PLD register.

The payload in TX FIFO in a PTX is not removed if the MAX_RT IRQ is asserted.

Figure 30. FIFO (RX and TX) block diagram

You can read if the TX and RX FIFO are full or empty in the FIFO_STATUS register.

8.5

Interrupt

The nRF24L01+ has an active low interrupt (IRQ) pin. The IRQ pin is activated when TX_DS IRQ, RX_DR

IRQ or MAX_RT IRQ are set high by the state machine in the STATUS register. The IRQ pin resets when

MCU writes '1' to the IRQ source bit in the STATUS register. The IRQ mask in the CONFIG register is used

to select the IRQ sources that are allowed to assert the IRQ pin. By setting one of the MASK bits high, the

corresponding IRQ source is disabled. By default all IRQ sources are enabled.

Note:

The 3 bit pipe information in the STATUS register is updated during the IRQ pin high to low

transition. The pipe information is unreliable if the STATUS register is read during an IRQ pin

high to low transition.

Data

TX FIFO

32 byte

TX FIFO Controller

Data

Control

SPI

command

decoder

RX FIFO

32 byte

RX FIFO Controller

Data

Control

NRF24L01P-R7 Datasheet(PDF) 56 Page - Nordic Semiconductor