4

Raspberry Pi Codec Zero – Raspberry Pi Ltd

WARNINGS

•

This product should only be connected to a Raspberry Pi via the GPIO header.

•

Any external power supply used with this product should comply with relevant regulations and standards applicable

in the country of intended use.

•

This product should be operated in a well-ventilated environment. If used inside a case, the case should not be

covered.

•

Whilst in use, this product should be placed on a stable, flat, non-conductive surface, and should not be contacted by

conductive items.

•

The connection of incompatible devices to the Raspberry Pi Codec Zero may affect compliance, result in damage to

the unit, and invalidate the warranty.

•

The connection of incompatible devices to the GPIO connection of a Raspberry Pi computer may affect compliance

and result in damage to the unit and invalidate the warranty.

•

All peripherals used with this product should comply with relevant standards for the country of use, and should be

marked accordingly to ensure that safety and performance requirements are met.

•

The cables and connectors of all peripherals used with this product must have adequate insulation so that relevant

safety requirements are met.

•

Operation of this device requires adult supervision.

SAFETY INSTRUCTIONS

To avoid malfunction or damage to this product, please observe the following:

•

Do not expose the product to water or moisture, or place it on a conductive surface while it is in operation.

•

Do not expose the product to heat from any source; Raspberry Pi computers and the Raspberry Pi Codec Zero are

designed for reliable operation at normal ambient temperatures.

•

Take care whilst handling to avoid mechanical or electrical damage to the printed circuit board and connectors.

•

In order to minimise the risk of electrostatic discharge damage, avoid handling the Raspberry Pi Codec Zero while it

is powered. If it is necessary to do so, handle it only by the corners.

Physical specification

65

58

40

23

17.5

42

53

3.5

3.5

Note: all dimensions in mm

4 x M2.5 Holes in corners