E5CC-RX2ABM-000 datasheet(89/138 Pages) OMRON

89 / 138 page

E5CC-T

Nomenclature

Dimensions

(Unit: mm)

Controllers

No. 1 display

No. 2 display

PV or specified monitor/setting parameter

SP or specified monitor/parameter value

Top-panel Setup Tool port

Use the

UD Keys to set the

parameter.

Press

U Key for at least 1 second

when Process value/Set point

parameter are displayed in Program

SP Mode to go to Display Segment

Selection parameter in Program

Setting Level.

Top View of E5CC-T

Operation indicators

Temperature unit

Press

O Key once to go to

Program Setting Level.

Press

O Key for at least 3

seconds to go to Initial Setting

Level.

Use the

M Key to change to another parameter.

Press

M and D Keys simultaneously for at

least 1 second to switch between run and reset

status.

Use

S Key to change the digit (default setting).

Front panel

E5CC-T

45+0.6

60 min.

(48 × number of units - 2.5)+1.0

Panel Cutout

Mounted Separately

Group Mounted

Group mounting does not

allow waterproofing.

48 × 48

(64)

48 × 48

Mounting Adapter

(Accessory, Y92F-49

(also available for

ordering separately))

Waterproof Packing

(Accessory, Y92S-P8

(also available for

ordering separately))

E5CC-T

• Recommended panel thickness is 1 to 5 mm.

• Group mounting is not possible in the vertical direction. (Maintain

the specified mounting space between Controllers.)

• To mount the Controller so that it is waterproof, insert the water-

proof packing onto the Controller.

• When two or more Controllers are mounted, make sure that the

surrounding temperature does not exceed the allowable operating

temperature specified in the specifications.

• Use a control panel thickness of 1 to 3 mm if the Y92A-48N and a

USB-Serial Conversion Cable are used together.

The Setup Tool port is on the top of the Temperature Controller.

It is used to connect the Temperature Controller to the computer

to use the Setup Tool.

The E58-CIFQ2 USB-Serial Conversion Cable is required to

make the connection.

Refer to the instructions that are provided with the USB-Serial

Conversion Cable for the connection procedure.

Note: Do not leave the USB-Serial Conversion Cable

connected when you use the Temperature Controller.

E5CC-RX2ABM-000 Datasheet(PDF) 89 Page - Omron Electronics LLC

E5CC-RX2ABM-000 Datasheet(HTML) 89 Page - Omron Electronics LLC

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL