Remote Configuration

The remote function can be used to configure the sensor remotely or to disable the push button for security. Connect the

gray wire of the sensor to ground (0 V dc), with a remote programming switch connected between them. Pulse the remote

line according to the diagrams in the configuration procedures. The length of the individual programming pulses is equal to

the value T where: 0.04 seconds ≤ “T” ≤ 0.8 seconds

Installation

Wiring Diagrams

Cabled Models

QD Models

bn

Remote

Teach

bu

wh

bk

gy

+

10-30V dc

–

Load

Load

bn

Remote

Teach

bu

wh

bk

gy

+

10-30V dc

–

Load

Load

Glass Fiber Installation

O-ring

Retaining Clip

1. Install the O-ring (supplied with the fiber) on each fiber end, as

shown in the drawing.

2. While pressing the fiber ends firmly into the ports on the sensor

front, slide the U-shaped retaining clip (supplied with the sensor)

into the slot in the sensor's barrel, until it snaps into place.

Plastic Fiber Installation

Trimmed fiber

control ends

Plastic fiber

emitter port

Plastic fiber

receiver port

Gripper

Unlock

Lock

Adapters for

0.25- and 0.5-mm fibers

Sensor Face

1. With supplied fiber cutter, make a clean cut at the control

ends of fibers.

2. Unlock the fiber gripper as shown in the drawing.

3. Apply appropriate fiber adaptors to the fiber, if needed.

4. Gently insert the prepared fiber ends into the ports as far

as they will go.

5. Slide the fiber gripper back to lock, as shown in the

drawing.

MINI-BEAM Expert Series

P/N 68812 Rev. C

www.bannerengineering.com - Tel: +1-763-544-3164

3