www.element14.com

www.farnell.com

www.newark.com

Page <1>

V1.1

03/07/17

Split Cable Wrap

Description

Split Cable Wrap is a non-expandable sleeving woven from monofilament (weft) and multifilament (warp) polyester yarns.

It provides a lightweight, cost-effective and tough solution for the protection of a wide range of components. Its inherent

flexibility allows it to bend, coil and conform to irregular shapes, while its split design allows it to be installed on assembled cable

harnesses.

Applications

Most commonly used on wire harnesses, cable assemblies, flat ribbon cables, tubes and hoses to provide tough, durable protection

for automotive, telecom, automatic equipment, railways and panel boards.

Technical Data

Material

: Polyester monofilament and multifilament yarns

Operating Temperature

: -50°C to +150°C

Melt Point

: 240°C ±10°C

Flammability

: DIN5510, BS6853

Colours

: Black

Cutting Tool

: Hot knife

Part Number Table

Description

Inner Diameter

Max.

Bundle Dia.

Spool

Length

Part Number

Split Cable Wrap

5mm

6mm

250m

PP001469

8mm

9mm

200m

PP001470

10mm

11mm

150m

PP001471

13mm

14mm

80m

PP001472

16mm

17mm

25m

PP001473

19mm

20mm

25m

PP001474

25mm

27mm

25m

PP001475

29mm

31mm

25m

PP001476

32mm

34mm

25m

PP001477

38mm

40mm

25m

PP001478

50mm

52mm

25m

PP001479

Important Notice : This data sheet and its contents (the “Information”) belong to the members of the Premier Farnell group of companies (the “Group”) or are licensed to it. No licence is granted

for the use of it other than for information purposes in connection with the products to which it relates. No licence of any intellectual property rights is granted. The Information is subject to change

without notice and replaces all data sheets previously supplied. The Information supplied is believed to be accurate but the Group assumes no responsibility for its accuracy or completeness, any

error in or omission from it or for any use made of it. Users of this data sheet should check for themselves the Information and the suitability of the products for their purpose and not make any

assumptions based on information included or omitted. Liability for loss or damage resulting from any reliance on the Information or use of it (including liability resulting from negligence or where the

Group was aware of the possibility of such loss or damage arising) is excluded. This will not operate to limit or restrict the Group’s liability for death or personal injury resulting from its negligence.

Multicomp is the registered trademark of the Group. © Premier Farnell Limited 2016.