Dual In Line Switches - Piano Type

MCEPX-XX-1

MCEPX-XX

PART NO.

REVISIONS

MCEP Series

ECN #

REV

DESCRIPTION

DRAWN

DATE

CHECKD

DATE

APPRVD

DATE

-

1.0

RELEASED

AB

19/01/16

ER

19/01/16

ER

19/01/16

Important Notice : This data sheet and its contents (the “Information”) belong to the members of the

Premier Farnell group of companies (the “Group”) or are licensed to it. No licence is granted for the use of

it other than for information purposes in connection with the products to which it relates. No licence of any

intellectual property rights is granted. The Information is subject to change without notice and replaces all

data sheets previously supplied. The Information supplied is believed to be accurate but the Group assumes

no responsibility for its accuracy or completeness, any error in or omission from it or for any use made of

it. Users of this data sheet should check for themselves the Information and the suitability of the products

for their purpose and not make any assumptions based on information included or omitted. Liability for loss

or damage resulting from any reliance on the Information or use of it (including liability resulting from negli-

gence or where the Group was aware of the possibility of such loss or damage arising) is excluded. This will

not operate to limit or restrict the Group’s liability for death or personal injury resulting from its negligence.

Multicomp is the registered trademark of the Group. © Premier Farnell plc 2012.

TOLERANCES:

UNLESS OTHERWISE

SPECIFIED,

DIMENSIONS ARE

FOR REFERENCE

PURPOSES ONLY.

DRAWN BY:

DATE:

DRAWING TITLE:

AB

19/01/16

CHECKED BY:

DATE:

SIZE

DWG NO.

ELECTRONIC FILE

REV

ER

19/01/16

APPROVED BY:

DATE:

SCALE:

U.O.M.:

SHEET:

ER

19/01/16

www.element14.com

www.farnell.com

www.newark.com

NTS

A4

1.0

4 of 4

mm (inch)

Soldering Process:

Wave soldeing

: Recommended solder temperature at 500°F ( 260°C) maximum of 5 seconds for through hole type

Hand soldering : Use a soldering iron of 30 watts, controlled at 350°C approximately maximum 5 seconds while applying

Reflow soldering : When applying reflow soldering, the peak temperature or the reflow Oven should be set at 260°C max.

Do not wash the switch except top tape sealed type, which suitable for spray cleaning method from top of the s/w

Part Number Table

Description

Number of

Positions

Part Number

Dual In Line Switches

Piano Type

2

MCEPI-02

4

MCEPI-04

6

MCEPI-06

8

MCEPI-08

10

MCEPI-10

2

MCEPM-02

4

MCEPM-04

6

MCEPM-06

8

MCEPM-08

10

MCEPM-10