STR750F datasheet(23/73 Pages) STMICROELECTRONICS

23 / 73 page

STR750F

Electrical parameters

23/71

Electrical parameters

3.1

Parameter conditions

Unless otherwise specified, all voltages are referred to VSS.

3.1.1

Minimum and maximum values

Unless otherwise specified the minimum and maximum values are guaranteed in the worst

conditions of ambient temperature, supply voltage and frequencies by tests in production on

100% of the devices with an ambient temperature at TA=25° C and TA=TAmax (given by the

selected temperature range).

Data based on product characterisation, design simulation and/or technology characteristics

are indicated in the table footnotes and are not tested in production. Based on

characterization, the minimum and maximum values refer to sample tests and represent the

mean value plus or minus three times the standard deviation (mean±3

Σ).

3.1.2

Typical values

Unless otherwise specified, typical data are based on TA=25° C, VDD_IO=3.3 V (for the

3.0 V

≤VDD_IO≤3.6 V voltage range) and V18=1.8 V. They are given only as design guidelines

and are not tested.

Typical ADC accuracy values are determined by characterization of a batch of samples from

a standard diffusion lot over the full temperature range, where 95% of the devices have an

error less than or equal to the value indicated (mean±2

Σ).

3.1.3

Typical curves

Unless otherwise specified, all typical curves are given only as design guidelines and are

not tested.

STR750F Datasheet(PDF) 23 Page - STMicroelectronics