WM8590GEDSSLASHV datasheet(21/51 Pages) WOLFSON

21 / 51 page

Pre-Production

WM8590

PP Rev 3.3 September 2005

2S MODE

In I

2S mode, the MSB of DIN is sampled by the WM8590 on the second rising edge of DACBCLK

following a DACLRC transition. The MSB of the ADC data is output on DOUT and changes on the

first falling edge of ADCBCLK following an ADCLRC transition and may be sampled on the rising

edge of ADCBCLK. ADCLRC and DACLRC are low during the left samples and high during the right

samples.

LEFT CHANNEL

RIGHT CHANNEL

DACLRC/

ADCLRC

DACBCLK/

ADCBCLK

DIN/

DOUT

1/fs

n-2 n-1

LSB

MSB

n-2 n-1

LSB

MSB

1 BCLK

Figure 14 I

2S Mode Timing Diagram

DSP MODES

In DSP/PCM mode, the left channel MSB is available on either the 1

st (mode B) or 2nd (mode A)

rising edge of BCLK (selectable by LRP) following a rising edge of LRC. Right channel data

immediately follows left channel data. Depending on word length, BCLK frequency and sample rate,

there may be unused BCLK cycles between the LSB of the right channel data and the next sample.

In device master mode, the LRC output will resemble the frame pulse shown in Figure 15 and Figure

16. In device slave mode, Figure 17 and Figure 18, it is possible to use any length of frame pulse

less than 1/fs, providing the falling edge of the frame pulse occurs greater than one BCLK period

before the rising edge of the next frame pulse.

Figure 15 DSP/PCM Mode Audio Interface (mode A, LRP=0, Master)

WM8590GEDS/V Datasheet(PDF) 21 Page - Wolfson Microelectronics plc