MODEL: 18KJV

18KJV SPECIFICATIONS

ES-0462 Rev.2 Page 1/3

http://www.m-system.co.jp/

Rack-mounted DCS Signal Conditioners 18K-RACK

SIGNAL TRANSMITTER

(field-programmable)

Functions & Features

• Software setting of input range via programming unit

(model: PU-2x) is available

• Module can be retracted without removing wiring for an

insulation test

MODEL: 18KJV–[1]66–R

ORDERING INFORMATION

• Code number: 18KJV-[1]66-R

Specify a code from below for [1].

(e.g. 18KJV-666-R)

• Special input range (For codes U1, U2 & U3)

[1] INPUT

Current

A: 4 – 20 mA DC (Input resistance 250 Ω)

H: 10 – 50 mA DC (Input resistance 100 Ω)

Voltage

6: 1 – 5 V DC (Input resistance 1 MΩ min.)

U1: Range ±100 mV;

(Minimum span 3 mV, Input resistance 20 kΩ min.)

U2: Range ±1000 mV;

(Minimum span 30 mV, Input resistance 20 kΩ min.)

U3: Range ±10 V;

(Minimum span 0.3 V,Input resistance 1 MΩ min.)

OUTPUT 1

Voltage

6: 1 – 5 V DC (Load resistance 2000 Ω min.)

OUTPUT 2

Voltage

6: 1 – 5 V DC (Load resistance 2000 Ω min.)

POWER INPUT

DC Power

R: 24 V DC

(Operational voltage range 24 V ±10 %, ripple 10 %p-p max.)

RELATED PRODUCTS

• Programming Unit (model: PU-2x)

• PC configurator software (model: JXCON)

Downloadable at M-System’s web site.

A dedicated cable is required to connect the module to the

PC. Please refer to the internet software download site or

the users manual for the PC configurator for applicable

cable types.

GENERAL SPECIFICATIONS

Construction: Rack-mounted; terminal access via screw

terminals on the front and connector on the rear; terminal

cover provided

Connection

Input: M3.5 screw terminals (torque 0.8 N·m)

and connector

Output 1: Connector

Output 2: M3.5 screw terminals (torque 0.8 N·m)

and connector

Power input: Supplied from connector

Screw terminal: Nickel-plated steel

Isolation: Input to output 1 to output 2 to power

Overrange output: Approx. -10 to +120 % at 1 – 5 V

Adjustments: Programming Unit (model: PU-2x); Input

range, zero and span, simulating output, etc.

(Input range can be changed with Codes U1, U2 or U3 and

limited within ranges of each code type.)

(Refer to the users manual of JXCON for the adjustments

configurable with JXCON.)

INPUT SPECIFICATIONS

■ DC Current: Input resistor incorporated

■ DC Voltage: -10 – +10 V DC

Minimum span: 3 mV

Offset: Max. 3 times span

Default setting will be used if not otherwise specified.

U1: 0 – 100 mV DC

U2: 0 – 1 V DC

U3: 0 – 10 V DC

OUTPUT SPECIFICATIONS

With the input voltage code 6, U3 (0 % ≥ 0 V) and current,

the output goes below 0 % when the input is open.