M2AC-AD3-R/Q
AI

The **M2AC-AD3-R/Q** is a specific model within the **M2 Series** of signal conditioners manufactured by **M-System**. This device is a compact, plug-in type signal conditioner designed to convert an AC current input into a standard DC output.
Below is the breakdown of its electronic components and specifications based on the model suffix:
---
## 1. Model Code Breakdown
The alphanumeric suffix defines the specific electronic characteristics of the unit:
| Code Segment | Description | Specific Detail |
| :--- | :--- | :--- |
| **M2AC** | Base Model | AC Transmitter (Input: AC, Output: DC) |
| **AD3** | Input/Output Spec | Input: 0–5A AC | Output: 0–10V DC |
| **R** | Power Input | 24V DC (Standard) |
| **Q** | Options | Specific customization (often involves conformal coating or special labeling) |
---
## 2. Key Electronic Specifications
The internal circuitry is designed for precision measurement and isolation.
### Input Section (AC Input)
* **Input Frequency:** 40 Hz to 1 kHz.
* **Input Impedance:** The unit uses a low-resistance shunt or a small internal current transformer (CT) to minimize the burden on the primary loop.
* **Overload Capacity:** Typically supports 500% of input for 5 seconds.
### Output Section (DC Output)
* **Signal Type:** 0–10V DC.
* **Load Resistance:** Minimum $10k\Omega$.
* **Response Time:** $\le 0.5$ seconds (0–90%).
* **Ripple:** $\le 0.5\%$ p-p.
### Power & Isolation
* **Power Supply:** 24V DC ($\pm 10\%$), ripple 10% p-p max.
* **Isolation:** 3-way isolation (Input to Output to Power).
* **Isolation Resistance:** $\ge 100M\Omega$ at 500V DC.
* **Dielectric Strength:** 2000V AC @ 1 minute.
---
## 3. Physical & Electronic Interface
The device uses a standard **8-pin plug-in base** (Socket) for electrical connections.
### Pin Configuration (Standard M2 Series)
| Pin No. | Function | Description |
| :--- | :--- | :--- |
| 1 | Output (+) | DC 0–10V Positive |
| 2 | Output (-) | DC 0–10V Negative |
| 3 | Input (U) | AC Input (Line) |
| 4 | Input (V) | AC Input (Neutral) |
| 7 | Power (U+) | 24V DC Positive |
| 8 | Power (V-) | 24V DC Negative |
---
## 4. Internal Processing Logic
The M2AC-AD3 uses an **Average Sensing** circuit to rectify the AC signal.
1. **Rectification:** The AC input is passed through a precision rectifier.
2. **Smoothing:** The rectified signal is filtered to obtain a DC mean value.
3. **Scaling:** The signal is calibrated so that the average value corresponds to the RMS value of a sine wave.
4. **Isolation:** The signal is transmitted across an optical or transformer-based isolation barrier to the output stage.
---
- ⤷
Does the 'Q' option specifically indicate a conformal coating for harsh environments?
- ⤷ What is the power consumption in Watts for the M2AC-AD3-R model?
- ⤷ Can this device handle non-sinusoidal AC waves accurately?