408- 9414

Terminating Head 58063- 2

3

of 4

Rev B

Tyco Electronics Corporation

Figure 4

Centerline of

Conductor

Correct

Acceptable

Termination Inspection

Incorrect

Wire Was Not Inserted

Deep Enough During

Termination

Wire Was Not Inserted

Straight Before

Termination

Wire Was Not Fully

Inserted Before

Termination

Wire Was Inserted With

Too Much Force During

Termination

Damaged Housing—

Connector Was Too

Tight or Too Loose in

Head During Termination

A

A

0.84+0.10 mm

[.033+.004 in.]

Section A--A

Arms of Insulation Support

Barrel Partially Closed

Arms of Insulation Support

Barrel Completely Closed

AMPLIMITE HDE--20

Receptacle Connector

0.51 mm

[.020 in.]

Min

for the head. One inspection per month is the

recommended frequency; however, operator training

and skill, amount of use, working conditions, and

established company standards are all factors to be

considered in establishing inspection frequency.

5.2. Daily Maintenance

1. Remove dust, moisture, and other contaminants

with a clean, soft brush or lint--free cloth. DO NOT

use objects that could damage the head.

2. Make sure that all components are in place and

properly secured.

3. Make sure that the mechanisms inside the head

function smoothly.

5.3. Periodic Maintenance

1. Remove any accumulated film with a suitable

cleaning agent that will not affect plastic.

2. Check for chipped, cracked, worn, or broken

areas on the head. If damage is evident, repair or

replace the head.

6. REPLACEMENT AND REPAIR

Customer--replaceable parts are listed in Figure 5.

A complete inventory should be stocked and

controlled to prevent lost time when replacement of

parts is necessary. Parts other than those listed

should be replaced by Tyco Electronics to ensure

quality and reliability. Order replacement parts

through your representative, or call 1--800--526--5142,

or send a facsimile of your purchase order to

717--986--7605, or write to:

CUSTOMER SERVICE (038--035)

TYCO ELECTRONICS CORPORATION

PO BOX 3608

HARRISBURG PA 17105--3608

For customer repair service, call 1--800--526--5136.