![]() |
Electronic Components Datasheet Search |
|
408-32217 Datasheet(PDF) 1 Page - TE Connectivity Ltd |
|
|
408-32217 Datasheet(HTML) 1 Page - TE Connectivity Ltd |
1 / 4 page ![]() Instruction Sheet 1 of 4 © 2015 TE Connectivity family of companies All Rights Reserved *Trademark TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product, and/or company names may be trademarks of their respective owners. PRODUCT INFORMATION 1-800-522-6752 This controlled document is subject to change. For latest revision and Regional Customer Service, visit our website at www.te.com. 408-32217 23 DEC 15 Rev A Figure 1 1. INTRODUCTION SFP+ cage assembly seating tool listed in Figure 1 is used to seat the cage assembly described in Figure 1 onto the pc board. The cage assembly contains compliant pin contacts to allow solderless pc board installation. Read these instructions thoroughly before using the seating tool kit. NOTE Dimensions on this sheet are in metric units [with U.S. customary units in brackets]. Figures and illustrations are for reference only and are not drawn to scale. 2. DESCRIPTION (Figure 1) Each seating tool consists of a seating tool and a wall support. The seating tool has cutouts (two located on each side) to accept the protruding part of the standoffs of the cage assembly. The wall support must be installed into the ports of the cage assembly. The top of the seating tool provides a surface to accept the force applied by the application tool to seat the product onto the pc board. During seating, the back and sides of the seating tool protect the cage assembly from damage. The wall support supports the individual ports of the cage assembly. 3. REQUIREMENTS 3.1. PC Board Support Fixture (Customer Supplied) A pc board support must be used to provide proper support for the pc board and to protect the pc board and the connector and cage assembly from damage. The support fixture must be designed for specific needs using the following recommendations: it should be at least 25.4 mm [1 in.] longer and wider than the pc board it should have flat surfaces with holes or a channel large enough and deep enough to receive any protruding components of the product Small Form-Factor Pluggable (SFP+ EMI Gasket with Heat Sink and Light Pipe) Cage Assembly Seating Tool 2215085-[ ] Back of Seating Tool SEATING TOOL KIT SFP+ CAGE ASSEMBLY CONFIGURATION APPLICATION SPECIFICATION 2215085-1 1 X 4 114-13120 2215085-2 Compliant Pin Contact 1 X 4 Single-Piece Wall Support (For Clarity, Not Shown Installed) 1 X 4 Cage Assembly 2198243-6 PC Board Support Fixture (Ref) Printed Circuit (PC) Board (Ref) 1 X 4 Seating Tool (Bottomed on Cage Assembly) |
Similar Part No. - 408-32217 |
|
Similar Description - 408-32217 |
|
|
Link URL |
Privacy Policy |
ALLDATASHEET.COM |
Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Datasheet Upload | Contact us | Privacy Policy | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
Family Site : ic2ic.com |
icmetro.com |