Instruction Sheet

PIDG* and PLASTI- GRIP* Terminal

408--10029

LOC B

1

of 9

E

2010 Tyco Electronics Corporation, Berwyn, PA

All Rights Reserved

TE logo and Tyco Electronics are trademarks.

*Trademark. Other product names, logos, or company names might be trademarks of their respective owners.

TOOLING ASSISTANCE CENTER 1--800--722--1111

PRODUCT INFORMATION 1--800--522--6752

This controlled document is subject to change.

For latest revision and Regional Customer Service,

visit our website at www.tycoelectronics.com

08 DEC 10 Rev B

and Splice Crimping Heads

Figure 1

Battery

Lock

Battery

Cartridge

1725839--1

Battery Powered

Crimp Tool

Retract Button

Crimp Head

Mounting Holes

Typical DAHT

Crimp Head (Ref)

Quick--Release

Pins

DAHT Adapter

Assembly

1. INTRODUCTION

Crimping Heads 1--46121--0, 1--47386--0, 1--47386--4,

1--47387--0, 1--47387--7, 1--525690--0, and

1--525691--0 are designed to crimp PIDG Terminals

and Splices, and PLASTI--GRIP Terminals and

Splices onto solid or stranded copper wire size 26--14

AWG. Refer to Figure 2. The crimping heads are

used with Double Action Battery Powered Hand Tool

Kits 1213804--[ ].

The crimping heads can also be used with the

626 Double Action Pneumatic Tool Adapter

1213563--1.

This instruction sheet provides recommended

procedures for wire preparation, crimping head

installation, crimping, and maintenance and

inspection. For information concerning tool setup and

operation, refer to Customer Manual 409--10056

packaged with the battery tool kit.

Dimensions are in metric units with [inches in

brackets]. Figures and illustrations are for

reference only and are not drawn to scale.

Reasons for reissue are provided in Section 8,

REVISION SUMMARY.

2. DESCRIPTION

The crimping head consists of integral jaws which

close in an arc--like motion. After an operator locates

the terminal or splice between the crimping jaws and

inserts the stripped wire, the tool is activated to crimp

the terminal or splice to the wire.

NOTE

i

NOTE

i