114-13219

Rev C

10 of 10

6. VISUAL AID

The illustration below shows a typical application of this product line. This illustration should be used by

production personnel to ensure a correctly applied product. Applications which DO NOT appear correct should

be inspected using the information in the preceding pages of this specification and in the instructional material

shipped with the product or tooling.

FIGURE 8. VISUAL AID

NOTE: Connector and Cage Assembly 2X4 Configuration Shown

Requirements Also Apply to 2X1, 2X2, 2X5, 2X6, and 2X8 Configurations

SLIGHT BOW IN CAGE

ASSEMBLY PERMITTED

CONNECTOR AND CAGE

ASSEMBLY MUST NOT BE

DAMAGED IN ANY WAY

ALL COMPLIANT PIN CONTACTS

AND ALIGNMENT POSTS MUST

BE FULLY INSERTED INTO

MATCHING PC BOARD HOLES

CAGE ASSEMBLY PANEL

GROUND SPRINGS MUST BE

COMPRESSED BY BEZEL

BEZEL MUST NOT INTERFERE WITH

FUNCTION OF CAGE ASSEMBLY

MODULE LOCKING LATCHES

EMI/DUST PLUG (NOT SHOWN) MUST

BE INSTALLED IN ITS RESPECTIVE

PORT WHEN MODULE IS NOT MATED

WITH CAGE ASSEMBLY