114- 10011

Rev C

8

of 11

3.7. Assembly Procedures

Instruction Sheet 408--7819 provides specific assembly procedures. Figure 9 shows how the product fits

together. Insertion Tool 91002--[ ] may be used to help insert terminated wires and contacts into the housings if

needed. Refer to Instruction Sheet 408--7347.

Figure 9

Panel

Locking Tab

Detent

Cable

Discrete Wires

Alignment Groove

Entire Length of Collets

Must Grip Cable Jacket

Polarizing Rib

Contacts Inserted Into

Back of Plug Insert

Plug

Insert

Mounting

Fins

After Mating,

Turn Clockwise

to Tighten

Locking Tab Slot

3.8. Repair/Replacement

If a damaged contact is apparent before the contacts are inserted into the housing, cut the wire in back of the contact

and reterminate the wire end. If contacts or housing are damaged after insertion, the wire must be cut directly in back

of the housing and reterminated with new contacts and housing. See Section 5, TOOLING.

Contacts are not repairable once a termination has been made. Any defective contact should be removed and

replaced with a new one. Damaged contacts can be removed from the housing by using Extraction Tool

91136--1. Refer to Instruction Sheet 408--7859 for extraction procedures.

4. QUALIFICATION

Audio/Microphone Connectors are not required to be agency approved.

CAUTION

!