2

AT49BV001A(N)(T)

3364C–FLASH–9/03

When the device is deselected, the CMOS standby current is less than 50 µA. For the

AT49BV001AN(T), pin 1 for the PLCC package and pin 9 for the TSOP package are no con-

nect pins. To allow for simple in-system reprogrammability, the AT49BV001A(N)(T) does not

require high input voltages for programming. Five-volt-only commands determine the read and

programming operation of the device. Reading data out of the device is similar to reading from

an EPROM; it has standard CE, OE, and WE inputs to avoid bus contention. Reprogramming

the AT49BV001A(N)(T) is performed by erasing a block of data and then programming on a

byte by byte basis. The byte programming time is a fast 30

µs. The end of a program cycle can

be optionally detected by the DATA polling feature. Once the end of a byte program cycle has

been detected, a new access for a read or program can begin. The typical number of program

and erase cycles is in excess of 10,000 cycles.

The device is erased by executing the erase command sequence; the device internally con-

trols the erase operations. There are two 8K byte parameter block sections, two main memory

blocks, and one boot block.

The device has the capability to protect the data in the boot block; this feature is enabled by a

command sequence. The 16K-byte boot block section includes a reprogramming lock out fea-

ture to provide data integrity. The boot sector is designed to contain user secure code, and

when the feature is enabled, the boot sector is protected from being reprogrammed.

In the AT49BV001AN(T), once the boot block programming lockout feature is enabled, the

contents of the boot block are permanent and cannot be changed. In the AT49BV001A(T),

once the boot block programming lockout feature is enabled, the contents of the boot block

cannot be changed with input voltage levels of 5.5 volts or less.

Block Diagram

CONTROL

LOGIC

Y DECODER

PARAMETER

BLOCK 1

(8K BYTES)

BOOT BLOCK

(16K BYTES)

OE

WE

CE

RESET

ADDRESS

INPUTS

VCC

GND

AT49BV001A(N)

DATA INPUTS/OUTPUTS

I/O7 - I/O0

8

X DECODER

PARAMETER

BLOCK 2

(8K BYTES)

MAIN MEMORY

BLOCK 1

(32K BYTES)

MAIN MEMORY

BLOCK 2

(64K BYTES)

PROGRAM

DATA LATCHES

Y-GATING

INPUT/OUTPUT

BUFFERS

1FFFF

10000

0FFFF

08000

07FFF

06000

05FFF

04000

03FFF

00000

PARAMETER

BLOCK 1

(8K BYTES)

BOOT BLOCK

(16K BYTES)

AT49BV001A(N)T

DATA INPUTS/OUTPUTS

I/O7 - I/O0

8

PARAMETER

BLOCK 2

(8K BYTES)

MAIN MEMORY

BLOCK 1

(32K BYTES)

MAIN MEMORY

BLOCK 2

(64K BYTES)

PROGRAM

DATA LATCHES

Y-GATING

INPUT/OUTPUT

BUFFERS

1FFFF

1C000

1BFFF

1A000

19FFF

18000

17FFF

10000

0FFFF

00000