5

0520F–FLASH–9/08

AT29LV010A

4.8

Optional Chip Erase Mode

The entire device can be erased by using a 6-byte software code. Please see Software Chip

Erase application note for details.

4.9

Boot Block Programming Lockout

The AT29LV010A has two designated memory blocks that have a programming lockout feature.

This feature prevents programming of data in the designated block once the feature has been

enabled. Each of these blocks consists of 8K bytes; the programming lockout feature can be set

independently for either block. While the lockout feature does not have to be activated, it can be

activated for either or both blocks.

These two 8K memory sections are referred to as boot blocks. Secure code which will bring up a

system can be contained in a boot block. The AT29LV010A blocks are located in the first 8K

bytes of memory and the last 8K bytes of memory. The boot block programming lockout feature

can therefore support systems that boot from the lower addresses of memory or the higher

addresses. Once the programming lockout feature has been activated, the data in that block can

no longer be erased or programmed; data in other memory locations can still be changed

through the regular programming methods. To activate the lockout feature, a series of seven

program commands to specific addresses with specific data must be performed. Please see

Boot Block Lockout Feature Enable Algorithm.

If the boot block lockout feature has been activated on either block, the chip erase function will

be disabled.

4.9.1

Boot Block Lockout Detection

A software method is available to determine whether programming of either boot block section is

locked out. See Software Product Identification Entry and Exit sections. When the device is in

the software product identification mode, a read from location 00002H will show if programming

the lower address boot block is locked out while reading location 1FFF2H will do so for the upper

boot block. If the data is FE, the corresponding block can be programmed; if the data is FF, the

program lockout feature has been activated and the corresponding block cannot be pro-

grammed. The software product identification exit mode should be used to return to standard

operation.

5.

Absolute Maximum Ratings*

Temperature Under Bias............................... -55

° C to +125° C

*NOTICE:

Stresses beyond those listed under “Absolute

Maximum Ratings” may cause permanent dam-

age to the device. This is a stress rating only and

functional operation of the device at these or any

other conditions beyond those indicated in the

operational sections of this specification is not

implied. Exposure to absolute maximum rating

conditions for extended periods may affect device

reliability.

Storage Temperature .................................... -65

° C to +150° C

All Input Voltages (including NC Pins)

with Respect to Ground ...................................-0.6V to +6.25V

All Output Voltages

with Respect to Ground .............................-0.6V to V

Voltage on A9 (including NC Pins)

with Respect to Ground ...................................-0.6V to +13.5V