① Insert the cable straight

and obliquely from

above.

② Slightlypullthecable

tomakesurethetabs

arefirmlysecured.

③ Closetheactuator.

Ride on a left guide

Ride on a right guide

Correct insertion

Do not close the actuator as the cables ride on.

Do not move the cables back and forth and around as

the cables ride on the guide when the actuator is closed.

9

Operation

Precautions

1.How to insert

Insert the cable into the interspace between the mold walls

(

) at both ends of entrance where the connector is

inserted and the guide walls

(

)at both ends of

interior connector so the cable tabs are properly located.

Avoid insertion so the cables ride on any guide. Be

sure NOT to close the actuator as the cables ride on

any guide. It may cause conduction failure.

2.Precautions when mating /un-mating

Do not insert the cable in diagonal direction.

A part of the connector may touches the contacts

resulting in deformation of the contacts.



Insert the cable straight into the connector and hook

the cable tabs with the guide.

After insertion, slightly pull the cables to make sure

the cable tabs are firmly secured. No removal of the

cable means correct insertion.

In the event it is locked as the cables ride on a guide,

absolutely avoid moving the cable. In this case, open

the actuator and re-insert the cable as instructed in “

1.How to insert”

■

Precautions (mating/un-mating FFC with the retention tabs)

The product information in this catalog is for reference only. Please request the Engineering Drawing for the most current and accurate design information.