2

7738C–AVR–11/09

ATmega88 Automotive

1.

Electrical Characteristics

1.1

Absolute Maximum Ratings

Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress rating

only and functional operation of the device at these or any other conditions beyond those indicated in the operational sections of this

specification is not implied. Exposure to absolute maximum rating conditions for extended periods may affect device reliability.

Parameters

Test Conditions

Unit

Operating Temperature

–55 to +150

°C

Storage Temperature

–65 to +175

°C

Voltage on any Pin except RESET with respect to Ground

V

Voltage on RESET with respect to Ground

–0.5 to +13.0

V

Maximum Operating Voltage

6.0

V

DC Current per I/O Pin

DC Current V

30

200.0

mA

1.2

DC Characteristics

Parameters

Test Conditions

Symbol

Min.

Typ.

Max.

Unit

Input Low Voltage, except

XTAL1 and RESET pin

V

V

IL

-0.5

0.1V

CC

(1)

V

Input High Voltage, except

XTAL1 and RESET pins

(2)

V

Input Low Voltage,

XTAL1 pin

V

V

IL1

–0.5

+0.1V

CC

(1)

V

Input High Voltage,

XTAL1 pin

(2)

V

Input Low Voltage,

RESET pin

–0.5

(1)

V

Input High Voltage,

RESET pin

V

V

IH2

0.9V

CC

(2)

V

V

Input Low Voltage,

RESET pin as I/O

–0.5

(1)

V

Input High Voltage,

RESET pin as I/O

(2)

V

Notes:

1. “Max” means the highest value where the pin is guaranteed to be read as low

2. “Min” means the lowest value where the pin is guaranteed to be read as high

3. Although each I/O port can sink more than the test conditions (0.5 mA at V

(non-transient), the following must be observed:

1] The sum of all IOL, for ports B0 - B5, should not exceed 50 mA.

If IOL exceeds the test condition, VOL may exceed the related specification. Pins are not guaranteed to sink current greater

than the listed test condition.

(non-transient), the following must be observed:

1] The sum of all IOH, for ports B0 - B5 should not exceed 50 mA.

If IOH exceeds the test condition, VOH may exceed the related specification. Pins are not guaranteed to source current

greater than the listed test condition.