© 2022 CT MICRO INTERNATIONAL CORPORATION

Rev.1

ALL RIGHTS RESERVED.

Page 6

Aug, 2022

UVC3535OUJLA-D0

0.2W UV Power LED

Notes:

1. The cathode side of the device is denoted by the chamfer on the part body.

2. Electrical insulation between the case and the board is required. Do not electrically connect

either the anode or cathode to the slug.

3. Drawing not to scale.

4. All dimensions are in millimeters.

5. Unless otherwise indicated, tolerances are ± 0.10mm.

6. Please do not solder the emitter by manual hand soldering, otherwise it will damage the emitter.

7. Please do not use a force of over 3kgf impact or pressure on the lens of the LED, otherwise

it will cause a catastrophic failure.

*The appearance and specifications of the product may be modified for improvement without notice