Emitter Mechanical Dimensions

3

Notes:

1. The cathode side of the device is denoted by the chamfer on the part body.

2. Electrical insulation between the case and the board is required --- slug of device is not

electrically neutral. Do not electrically connect either the anode or cathode to the slug.

3. Drawing not to scale.

4. All dimensions are in millimeters.

5. All dimendions without tolerances are for reference only.

6. Please do not bend the leads of LED, otherwise it will damage the LED.

7. Please do not use a force of over 3kgf impact or pressure on the lens of the LED, otherwise

it will cause a catastrophic failure.

*The appearance and specifications of the product may be modified for improvement without notice.

TOP VIEW

BOTTOM VIEW