B32

12. Resistance to Corrosion

500M

ø min.

Neither short nor breakdown

0.2N

to 2N

No marked corrosion

■Product Specifications

Rating

Item

Specification

Condition

Nominal characteristic impedance

Rated frequency

50 ohms

DC-6GHz

Operating Temperature Range

Operating Relative Humidity

-55ç to +85ç

90

% max.

500V DC

500V AC / 1 minute

100mA (DC or 1000Hz)

Measured with the

Ø0.37 pin gauge.

Measured with an appropriate connector.

96 hours at temperature of 40ç and humidity of 90% to 95%

Exposed to density 5% salt water for 48 hours

No damage, cracks, or parts looseness.

Insulation resistance: 10M

ø min(High temperature)

Insulation resistance: 500M

ø min(Dry)

Contact resistance: 20m

ø max. (center)

10m

ø max. (outer)

No damage, cracks, or parts looseness.

10. Temperature Cycle

force (plug)

wave ratio

11. Operating Life

Contact resistance: 20m

ø max. (center)

10m

ø max. (outer)

No electrical discontinuity of 1μs or more

No damage, cracks, or parts looseness.

No electrical discontinuity of 1μs or more

No damage, cracks, or parts looseness.

1.2 max.

1.2 max. (MMCX-LR-SMT only)

1.4 max. (MMCX-LR-SMT only)

Insertion force: 15N max.

withdrawal force: 6

to 15N

10m

ø max. (center),

ø max. (outer)

Temperature of:

-55ç

➝+20 to 35ç ➝+85ç

➝+20 to 35ç

Time: 30 minutes

➝5 minutes max. ➝30 minutes ➝5 minutes min.

5 cycles

500 cycles

waveform, 3 cycles in each of the 3 axis

Frequency: 10 to 500 Hz, single amplitude of 0.75 mm or

DC

to 6GHz

DC

to 4GHz

4GHz

to 6GHz

Measured at 0.45GHz

to 6GHz

Parts

Body

Male center contact

Female center contact

Male/female in-line contact

Insulator

Fixing ring

Crimp sleeve

Cover

Material

Phosphor bronze

Beryllium bronze

Beryllium copper (conversion adaptor)

PTFE

Beryllium copper (plug)

Copper

Brass (plug)

Gold plating

Gold plating

Gold plating

––

Gold plating

Gold plating

Gold plating

Gold plating

Brass

Stainless steel (conversion adaptor)

Finish

■Material

*Voltage standing wave ratio (V.S.W.R.) measuring system.

The above voltage standing wave ratio (V.S.W.R.) standard value is measured in the measuring system as shown below.

NOTE 1 : The cable connector is measured with double ended 15cm cable

assembly.

NOTE 2 : The PCB connector is mounted on the 50 ohms printed circuit

board, to which Hirose's adaptor is connected.

Network Analyzer

Test Set

Test Port

Test Post Cable

D.U.T

Termination